Sanitizer Packets

Description

Stera Sheen sanitizer packets for cleaning soft-serve machines and other food grade supplies. (item #28300-27008)

Product Description
Composed of food-grade-safe components to help sanitize and maintain your equipment. This is both NSF and FDA approved.

Product Use
Stera Sheen Green Label Sanitizer is ideal for cleaning and sanitizing your soft serve equipment. This is also equipped with a milkstone remover which helps eliminate any harmful milkstone deposits that may accumulate over time, while still maintaining the integrity of any o-rings and seals inside your equipment. Scoop included.
​
​Additional Uses
Stera-Sheen Green Label is an EPA registered Sanitizer approved to clean and sanitize surfaces, including food contact surfaces. Once properly mixed Stera-Sheen Green Label can be used to wipe down surfaces such as door knobs, counter tops, tables, etc. Many customers mix Stera-Sheen Green Label in a Quart spray bottle for an easier application on surfaces. Below we have included directions for use with mixing ratios.

Spray Bottle Directions for Use

Recommended Mixing Ratio:  1 Tablespoon Stera-Sheen Green Label per 1 quart of water.  Warm water is recommended.  Powder should be full dissolved in water prior to use.

Cleaning

1. Remove any solids or debris from the surface.
2. Spray as necessary to completely coat the surface(s) with Stera-Sheen Green Label solution.
3. Brush clean and/or wipe with clean towel until visibly clean.

Sanitizing

1. Remove any solids or debris from the surface.
2. Spray as necessary to completely coat the surface with Stera-Sheen Green Label solution.
3. Allow to soak for at least 60 seconds.
4. Use clean towel to remove excess solution or to dry.

Bucket Directions For Use

Recommended Mixing Ratio:  1-2 ounces of Stera-Sheen Green Label with 1 gallon of water as needed

Cleaning

1. Saturate a clean towel or dip a brush in Stera-Sheen Green Label solution.
2. Brush and/or wipe until surface is visibly clean.

Sanitizing

1. Using a clean towel completely coat the surface with Stera-Sheen solution.
2. Allow to soak for at least 60 seconds.
3. Use clean towel to remove excess solution or to dry.

***Please Note:  Spray bottle should be indicated for use with Stera-Sheen Green Label Sanitizer & Cleaner solution only. Do not use or mix spray bottle with any other chemicals.  After 4 hours, Stera-Sheen Green Label Sanitizer & Cleaner solution should be retested to indicate available chlorine per your local health department requirements, or the solution should be discarded.  Mix new solution as needed following the correct dilution ratio.